RTL Studio Open IDE

1.4 · AXI CLASS

AXI4-Lite slave FSM: enum states and case transitions

Control AXI4-Lite transactions with an enum-based FSM and case state transitions.

Video coming soon. This lesson page stays at the same URL when the lecture publishes.

What you practice

AXI4-Lite slave FSM: enum states and case transitions (1.4). Control AXI4-Lite transactions with an enum-based FSM and case state transitions. It is in AXI4-Lite Slave FSM — Part 1 · AXI4-Lite RTL Design of the AXI Masterclass. Design an AXI4-Lite slave in pure SystemVerilog.

AXI only counts when the handshake simulates. RTL Studio is the Verilog and SystemVerilog IDE where you edit the RTL and prove each beat on a VCD.

Run it in the Verilog IDE

  1. Open the lesson in the IDE and find the valid/ready or AXI channel ports in the editor.
  2. Simulate with Verilator. Confirm the beat on the VCD, not only in the transcript.
  3. Check that data moves only on the beats this lesson describes, and that backpressure holds the transfer.
  4. Synthesize the RTL master, slave, or buffer with Yosys. Leave the UVM bench out of synthesis.

The lesson is done when the simulation matches AXI4-Lite slave FSM: enum states and case transitions. Change the source, run the Verilog simulator again, and read the waveform without leaving the IDE. Simulation guide · Yosys guide.

Open in IDE Course playlist